Knowledgebase
Powersave > My Help Desk > Knowledgebase

Ask a question:


How do I pair more than one transmitter to my EnviR?

Solution Press up/down on the display until you are showing Appliance 1 (or whichever spare channel you wish to use)

Then pair as before:

Press the red button for 10 seconds on the transmitter you wish to pair. When you release the button, the red led should flash repeatedly.
Then go to the display, press up / down until you are on the channel (Appliance) of choice then hold down the right (DOWN) button for 5 seconds then release.
The display will pair (and the EnviR will show 240 for about 1 minute representing the voltage).
If you have both a Envi and an EnviR I would pair both displays to the transmitter at the same time... ... as both displays can receive the signal from both transmitters.
 
Was this article helpful? yes / no
Article details
Article ID: 22
Category: Envi and EnviR information
Date added: 2011-08-17 12:01:35
Views: 63
Rating (Votes): Article not rated yet (0)

 
<< Go back

Powered by Help Desk Software HESK™